Viewing 3D Content
This section provides information and procedures for setting up and managing 3D presentations.
Display requirements
To display 3D images with the CP2208 projector, you require these items:
•
A 3D hardware system:
•
Pi-Cell polarizer for display on a screen that has a silver polarization-preserving surface
for use with passive glasses (RealD).
•
Rotating polarizing wheel (external) with passive circular polarizing glasses
(MasterImage). Requires a silver screen.
•
IR emitter for controlling the left eye/right eye gating (switching) of active glasses
(Xpand).
•
Dual projector 3D - passive glasses (circular or linear). Requires a silver screen.
•
A 3D connection cable.
•
Power supply for your synchronization output device. The 3D sync port can power output
devices.
3D sync terminal pin map
The 3D Sync terminal is a 15-pin D-sub connector (female) located on the projector
communications panel. This table lists the control functions available through the 3D connector.
Pin
Signal name
1
+12V
2
GND
3
GND
4
RS232_RX
5
RS232_TX
CP2208 User Manual
020-101916-02 Rev. 1 (08-2015)
Direction
Description
Out
Power to 3D device. Maximum 1A (total between
both +12V pins).
/
Ground
/
Ground
In
Data to projector from 3D device. 1200 Baud, 8 bits,
no parity. Currently unsupported.
Out
Data to projector from 3D device. 1200 Baud, 8 bits,
no parity. Currently unsupported.
76