Christie CP2208 User Manual page 16

3. Insert an M6 screw (012-101132-XX) through the stacking cup mounting hole and into the
projector.
4. With a torque wrench, tighten the M6 screw to 15 in-lb.
5. Repeat steps 3 to 5 to install the three remaining stacking cups.
6. With the assistance of another person, lift the second projector and position it on top of the
bottom projector so each of its feet fit into a stacking cup. The lenses of both projectors must
face the same direction and the optical axis of both projector lenses must be parallel (A) and
align vertically (B).
7. Complete the installation for both projectors, including:
a. Install the touch panel controller. See
b. Install the lens. See
c. Install the lamp. See
d. Connect devices to the projector. See
e. Connect power. See
f. Adjust the bottom projector image to fit the screen. See
screen on page
g. Align the top projector image to the bottom projector image. See
images on page
8. When both projectors are installed and aligned correctly, install the locking brackets on the feet
of the top projector:
a. Slide the locking bracket (011-104470-XX) over the flat sides of the stacking cup, so the
notch in the locking bracket fits around the projector leg and above projector foot nut.
CP2208 User Manual
020-101916-02 Rev. 1 (08-2015)
Installing the touch panel controller
Installing the lens on page
Installing the lamp on page
Connecting devices to the projector on page
Turning the projector on on page
30.
32.
Installing and Setting Up
18.
20.
27.
Adjusting the image to fit the
Aligning dual projector
on page 18.
23.
16