Adding The Projector To A Network; Adding The Lamp Information To The Lamp History - Christie CP2208 User Manual

Adding the projector to a network

1. On the touch panel controller (TPC), tap Menu > Login.
2. Select an administrator account in the Username list.
3. Enter a password in the Password field and then tap Login.
4. Tap Menu > Administrator Setup > Communications Configuration.
5. Complete these fields:
Field
Device Name
IP Address
Subnet Mask
Gateway
Apply
Serial Speed (Baud)
Enable SNMP
SNMP V2 / SNMP V3
Management IP
Download MIB to USB
Apply
Serial Access
Ethernet Access

Adding the lamp information to the lamp history

1. If the lamp is on, tap the lamp off (
2. Tap Menu > Advanced Setup > Lamp Change Wizard.
3. Tap Next.
4. Complete these fields:
Field
Type
Serial Number
Reason for Change
CP2208 User Manual
020-101916-02 Rev. 1 (08-2015)
Description
The name of the projector.
The IP address of the projector.
The subnet mask to which the address belongs.
The IP address for the network gateway.
Applies Ethernet settings.
The baud rate of the serial port. The default is 115200.
Enables SNMP.
The SNMP protocol type. Contact Christie for the SNMP V3 user ID and
password.
The IP address where SNMP information and notifications are sent.
Sends the SNMP Management Information Base (MIB) file to a USB flash
drive.
Applies SNMP settings.
Grants access to serial connections.
Grants access to Ethernet connections.
) icon to turn it off.
Description
The lamp type.
The lamp serial number.
The reason the lamp was changed.
Installing and Setting Up
28