Adjusting Tilt And Level The Projector - Christie CP2208 User Manual

b. Turn the locking bracket so the flanges of the locking bracket fit tightly below the
stacking cup tabs.
c. Repeat steps a and b to install the three remaining locking brackets.

Adjusting tilt and level the projector

To ensure optimum performance of the projector, install the projector so it is centered and parallel
with the screen. To compensate for tilt or offset, you can adjust the projector feet and the lens
mount position.
To adjust the height of the projector, loosen the lock nut on the adjustable feet on the bottom of the
projector and then extend or retract the feet. When the adjustment is correct, tighten the lock nut.
Use the lens mount to align the images of stacked projectors and not projector tilt. If tilt is required
to fit the image to the screen, tilt only the lower projector.
The front-to-back tilt of the projector must not exceed 15°.
CP2208 User Manual
020-101916-02 Rev. 1 (08-2015)
Installing and Setting Up
17