Aligning Dual Projector Images - Christie CP2208 User Manual

Aligning dual projector images

1. Stack the projectors. See
2. On the bottom projector, adjust the image to fit the screen. See
screen on page
3. On both projectors, turn the lamp on and open the douser. See
29.
4. On the top projector, display a RGB-12bit-Full Screen White test pattern and center the image:
a. Tap the Test Pattern (
b. Tap All Test Patterns.
c. Tap RGB-12bit-Full Screen White.
d. On the projector touch panel controller (TPC), tap the Lens Adjust (
main screen and then tap the left (
in the Offset area until the light created by the projector is centered on the screen.
5. On the top projector, display the DC2K Framing Green test pattern. See
pattern on or off
6. On the bottom projector, display the DC2K Framing Red test pattern. See pattern. See
Turning a test pattern on or off
7. Align the top projector image horizontally to the bottom projector:
a. On the top projector, remove the locking brackets from the projector feet.
b. Move the front or the rear of the top projector to the right or left so the projected image
is aligned horizontally with the image of the bottom projector.
8. Align the top and bottom projector images vertically:
CP2208 User Manual
020-101916-02 Rev. 1 (08-2015)
Stacking projectors
30.
) icon in the task bar.
on page 75.
on page
on page 15.
), right ( ), up (
75.
Installing and Setting Up
Adjusting the image to fit the
Turning the lamp on on page
) icon on the
), or down ( ) arrow icons
Turning a test
32