Projector Connections - Christie CP2208 User Manual

Projector connections

Item Description
Indicates the status of the regulator. A solid blue LED indicates the regulator is enabled. If the LED is not
A
illuminated, the regulator is not enabled.
• SOFTST - (Software State) Indicates the state of the software application running on the ICP. During
B
normal operation, this LED blinks. During start up, the LED changes from off to blinking.
• OSST - (Operating System State) Indicates the state of the ICP operating system. During normal
operation, the LED is green. During start up, the LED changes from off to green.
• FMTST - (FMT FPGA State) Indicates the state of the FMT FPGA. During normal operation, the LED is
green. When the power is turned on, the LED turns green immediately.
• ICPST - (ICP FPGA State) Indicates the configured state of the ICP FPGA. During normal operation,
the LED is green. When the power is turned on, the LED turns green immediately.
• PORT B - Indicates the status of the USB port. A green LED indicates the port is active. If the LED is
C
not illuminated, the port is inactive.
• PORT A - Indicates the status of the USB port. A green LED indicates the port is active. If the LED is
not illuminated, the port is inactive.
• STBY - The LED is green when the standby power supply is active. If the LED is not illuminated, the
D
standby power supply has failed or the projector circuit breaker is off.
• RUN - The LED flashes green when the projector is operating normally. If the LED is not illuminated or
solid green, a communication, software, or hardware error has occurred. If the LED is yellow, the
projector cannot communicate with the touch panel controller (TPC).
• PIB - The LED is green when the Projector Intelligence Board (PIB) is detected and operating
correctly. A red LED indicates a communication error. A flashing red LED indicates the PIB is not
installed correctly. If the LED is not illuminated, the PIB is inactive.
• ICP - The LED is green when the ICP is operating correctly. A red LED indicates a communication
issue. If the LED is not illuminated, the ICP is inactive.
• IMB - The LED is green when the Integrated Media Block (IMB) is operating correctly. A red LED
indicates a communication issue. If the LED is not illuminated, the IMB is inactive.
CP2208 User Manual
020-101916-02 Rev. 1 (08-2015)
Installing and Setting Up
24