Setting Up Hardware - Christie CP2208 User Manual

Pin Signal name
6 CONN_3D_MODE+
7 CONN_SYNC+
8 3D_INPUT_REFRERENCE+
9 +12V
10 3D_INPUT_REFRERENCE-
11 3D_DISPLAY_REFERENCE+
12 3D_DISPLAY_REFERENCE-
13 CONN_3D_MODE-
14 CONN_SYNC-
15 Not connected

Setting up hardware

Use an infrared emitter to control gating in active glasses, a polarizing Z-screen (Pi-cell) with
passive glasses or filter wheel with passive glasses.
RealD
Z-screen
Installed/ Z-screen
Mounted mounted in
Components front of the
projection
lens
Silver Screen Yes
CP2208 User Manual
020-101916-02 Rev. 1 (08-2015)
Direction Description
Out SYNC from projector. To projector GPO collector.
Compatible with current projector GPIO
requirements and restrictions. (24VDC max, 50mA
max)
3D ON = Hi logic level = O/P transistor ON
3D OFF = Low logic level = O/P transistor OFF
Out SYNC from projector. To projector GPO collector.
Compatible with current projector GPIO
requirements and restrictions. (24VDC max, 50mA
max)
In 3D L/R Input Reference (P)
(Voltage Limit: 2 VDC to 12VDC)
Out Power to 3D system. Maximum 1A (Total between
both +12V pins)
In 3D L/R Input Reference (N)
(Voltage limit: 1.4VDC to 12VDC)
In 3D L/R Input Reference (P)
(Voltage limit: 1.4VDC to 12VDC)
In 3D L/R Input Reference (P)
(Voltage limit: 1.4VDC to 12VDC)
Out 3D mode state from projector. From projector GPO
emitter. Compatible with current projector GPIO
requirements and restrictions. (24VDC max, 50mA
max)
Out SYNC from projector. From projector GPO emitter.
Compatible with current projector GPIO
requirements and restrictions. (24DC max, 50mA
max)
RealD XL Xpand
Box
XL box None
mounted in
front of the
projection
lens
Yes No
Viewing 3D Content
Master Dual
Image Projector
Wheel Polarizing
installed in plates in front
front of the of lenses
projector
Yes Yes
77