Installing The Lamp - Christie CP2208 User Manual

6. Insert and tighten the two lens mount hex screws shipped separately with the projector.
7. Lock the lens assembly in place with a hex key.
8. Replace the lens surround.

Installing the lamp

Danger! Failure to comply with the following results in serious injury.
This procedure should only be performed by a Christie accredited technician. High-pressure lamp
may explode if improperly handled. Always wear approved protective safety clothing whenever the
lamp door is open or when handling the lamp.
1. If the projector is operating, turn it off and allow it to cool a minimum of 15 minutes.
2. Turn the breaker switch for the projector off.
3. Disconnect the projector from AC power.
4. Disconnect the touch panel controller (TPC) communication cable from the rear of the projector.
5. Remove the TPC from the rear of the projector.
6. Put on your protective clothing, face shield, and gloves.
7. Insert the key in the lamp door lock, turn the key, and then open the lamp door.
CP2208 User Manual
020-101916-02 Rev. 1 (08-2015)
Installing and Setting Up
20