Christie CP2208 User Manual page 26

2. Loosen the threaded bolt on the ground lug on the AC receptacle on the rear corner of the
projector.
3. Remove 15 mm of insulated covering from both ends of the protected earth wire.
4. Insert a bare end of the protected earth wire into the hole on the top of the ground lug so it is
beneath the threaded bolt.
5. Tighten the threaded bolt to 50 in-lb.
6. Connect the other bare end of the protected earth wire to the building ground.
7. Connect one end of the projector power cord to the AC receptacle on the lower-left rear corner
of the projector and then connect the other end of the power cord to an AC receptacle.
8. If you are using an Uninterrupted Power Supply (UPS) to power the main electronics, move the
AC switch to A + B and connect the power cord provided with the UPS to the B outlet.
CP2208 User Manual
020-101916-02 Rev. 1 (08-2015)
AC Switch
A
100-240V secondary inlet
B
200-240V main inlet
C
Installing and Setting Up
26