Inspecting The Card Cage Filter; Inspecting The Light Engine Compartment Filter - Christie CP2208 User Manual

Inspecting the card cage filter

Caution! Failure to comply with the following could result in minor or moderate injury.
Use only high efficiency Christie approved filters. Never operate the projector without the filter
installed. Always discard used air filters.
You should check the condition of the card cage air filter monthly. Clean or replace the card cage air
filter sooner if you are operating the projector in a dusty or dirty environment. The filter is located
on the left side of the projector behind the air filter cover.
1. Loosen the two captive screws on the bottom of the filter cover.
2. Pull the cover out and down.
3. Slide the air filter out and inspect it.
If the filter appears dirty and you cannot see through it, replace it with a new paper filter, or
clean it if it is a washable filter. See
If the filter appears clean, continue to step 4.
4. Replace the air filter with the airflow indicator facing toward the projector.
5. Install the air filter cover by inserting the two bottom tabs and then pushing the cover closed.
6. Tighten the two captive screws.

Inspecting the light engine compartment filter

1. Remove the top lid.
CP2208 User Manual
020-101916-02 Rev. 1 (08-2015)
Cleaning a washable filter
Maintenance
on page 93.
91