Christie CP2208 User Manual page 31

d. On the projector touch panel controller (TPC), tap the Lens Adjust (
main screen and then tap the left (
in the Offset area until the light created by the projector is centered on the screen.
3. Display the DC2K Framing2 test pattern:
a. On the projector TPC, tap the Test Pattern (
b. Tap All Test Patterns.
c. Tap DC2K Framing2.
4. On the projector TPC, tap the Lens Adjust (
( ), right (
of the test pattern on the screen.
5. In the Zoom area, tap the positive (
6. In the Focus area, tap the left (
in focus. When your adjustment is complete, the words and lines in the test pattern should be
distinguishable uniformly across the screen and there should not be any sections that are out of
focus.
7. With the framing test pattern displayed, re-check projector leveling so the top edge of the
image is parallel to the top edge of the screen.
8. Display a full white test pattern:
a. On the TPC, tap the Test Pattern (
b. Tap All Test Patterns.
c. Tap RGB-12bit-Full Screen White.
9. If the test pattern is focused and centered on the screen you do not need to complete further
image adjustment. If the image is not focused and centered on the screen, complete one of
these procedures:
a. See Correcting keystone effect
a trapezoid.
b. See Correcting vignetting
brighter at the center than it is at the sides.
c. See Adjusting fold mirror
d. See Adjusting vertical boresight angle
uniformly on the screen with a focus adjustment.
e. See Adjusting horizontal boresight
screen is required.
CP2208 User Manual
020-101916-02 Rev. 1 (08-2015)
), up ( ), or down (
) and right (
on page 36 or
on page 40 if a corner or edge of an image is missing.
), right ( ), up (
) icon in the task bar.
) icon on the main screen and then tap the left
) arrow icons in the Offset area to refine the position
) and minus ( ) icons until the image fits your screen.
) focus icons until the test pattern details are
) icon in the task bar.
on page 34 if the image appears distorted and resembles
Aligning the lamp
on page 37 if the image cannot be focused
on page 38 if a large horizontal angular offset to the
Installing and Setting Up
) icon on the
), or down ( ) arrow icons
on page 29 if the image is
31