Editing The Default 3D Lamp File; Defining A Measured Color Gamut Data File - Christie CP2208 User Manual

Field
Dark Time
Output Delay
Phase Delay
4. Tap Save.

Editing the default 3D lamp file

For 3D images to display correctly, you must edit the default 3D lamp file to match the
specifications of your 3D hardware.
1. Tap Menu > Advanced Setup > Lamp Power / LiteLOC
2. Select Default 3D in the Current Lamp File list.
3. Set the brightness percentage for the lamp in the Power % field
4. Tap Save.

Defining a measured color gamut data file

For 3D images to display correctly, you must define an MCGD file to match the specifications of your
3D hardware.
1. Turn the lamp on and allow it to operate for 20 minutes.
2. Tap Menu > Advanced Setup > MCGD File Setup.
3. Hold a pair of 3D glasses in front of the light meter to determine the new x and y color
coordinates for Red, Green, Blue, and White. Use the same light path that you use to display a
show.
4. Enter the x and y values in the Red, Green, Blue and White fields.
5. Tap Save As.
6. Enter 3D Onsite in the File Name field.
7. Tap Save.
CP2208 User Manual
020-101916-02 Rev. 1 (08-2015)
Description
Creates a blank time interval between left and right frames to allow for
LCD shutter glasses, Z screen, or rotating 3D wheel to synchronize the
output. See Dark Time and Output Delay Notes below. Values between 0
and 65535 are accepted. Tap the Launch Dialog button
the dark time value.
The non-image time in Microseconds (μ). Offset 3D stereo sync output in
relation to dark time interval. Acceptable values are between -32768 and
32767 are accepted where a positive offset = delay and negative offset =
start early. Tap Launch Dialog to enter the output delay value.
The degree of reference between the left and right sync output. Values
between -180 and 180 are accepted. Tap Launch Dialog to enter the
phase delay value.
Viewing 3D Content
to enter
™
Setup.
.
79