Configuration Requirements - Polycom RealPresence RMX 1500 Administrator's Manual

Configuration Requirements

LAN Redundancy is disabled by default and is enabled by changing the LAN_REDUNDANCY system flag
to YES and connecting the appropriate LAN cables to the LAN ports on the Collaboration Server as follows:
RealPresence Collaboration Server (RMX) 1500
» Connect the additional LAN cable to LAN 1 port on the RTM IP.
RealPresence Collaboration Server 1800
» Connect the additional LAN cable to LAN 2 port on the rear panel of the Collaboration Server 1800.
RealPresence Collaboration Server (RMX) 2000
On a RealPresence Collaboration Server (RMX) 2000, one RTM LAN card is required.
For more information see the RealPresence Collaboration Server (RMX) 2000 Hardware Guide,
Installing or Replacing the RTM
● Connect the additional LAN cable to LAN 1 port on the RTM LAN.
● In the Setup> System Configuration > System Flags dialog box, add the flag
RMX2000_RTM_LAN and set it to YES to activate the installed RTM LAN card.
● On the RealPresence Collaboration Server (RMX) 2000, LAN Redundancy can be enabled
simultaneously with Multiple Networks. To enable the Multiple Networks option, set the
MULTIPLE_SERVICES flag to YES.
● A system reset is required when adding the RMX2000_RTM_LAN flag.
RealPresence Collaboration Server (RMX) 4000
● Connect the additional LAN cable to LAN 1 port on the RTM LAN.
● On the RealPresence Collaboration Server (RMX) 4000, LAN Redundancy can be enabled
simultaneously with Multiple Networks. To enable the Multiple Networks option, set the
MULTIPLE_SERVICES flag to YES.
● If required, reset the Collaboration Server.
On all systems:
● LAN Redundancy can be disabled by setting the LAN_REDUNDANCY System Flag to NO.
● If the LAN_REDUNDANCY System Flag value set to NO, the LAN 2 port must be connected to the
IP network.
On the RMX 1500/2000/4000, full media redundancy is supported if only one IP Network Service is
defined per media card.
Hardware Monitor Indications
When LAN Redundancy is enabled on the Collaboration Server, LAN 2 port is Active. With LAN
redundancy, when LAN LEDs are lit they indicate that a physical connection of the cables is present but
Polycom, Inc.
LAN.
IP Network Services
517