Installation Preparations; Site Safety Requirements; Installation Precautions - Polycom RealPresence RMX 4000 Hardware Manual

Installation Preparations

Topics:
▪

Site Safety Requirements

▪

Installation Precautions

▪ Rack Mount Safety Precautions
▪ Unpack RMX 4000
▪ Accessories Kits
• Install the Telescopic Rail Runners on the Rack
Site Safety Requirements
For your protection, please read these safety instructions completely before operating the equipment.
▪ Look carefully for potential hazards in your work area: moist floors, ungrounded power cables,
frayed power cords, missing safety grounds and so forth.
▪ Locate the main circuit breaker within the room.
▪ Locate the emergency power OFF switch within the room.
▪ Never assume that power is disconnected from a circuit.
▪ Use only the power cord(s) supplied with the system.
▪ The power cord(s) should only be connected to a power outlet that has a protective ground contact.
▪ Ensure that power cord(s) are easily accessible from the back of the system at all times.
▪ Do not place heavy objects directly on top of RMX 4000.
▪ Do not use liquids around your equipment.
▪ Place the equipment in a well-ventilated area where the vents are free from obstruction.
▪ Keep the area around the RMX 4000 clean and free of clutter.
The airflow of the 4000 is from right to left. Be sure that the areas on both sides of the system are
clear for proper ventilation.
▪ Decide on a suitable location for the equipment rack that will hold the RMX 4000 unit. It should be
situated in a clean, dust-free area that is well ventilated. Avoid areas where heat, electrical noise
and electromagnetic fields are generated. You will also need to place it near a grounded power
outlet.
Installation Precautions
Note: The RMX 4000 can weigh up to 40 kg when all slots are occupied. Two people are
required to lift the MCU out of the box and also when installing it in a rack.
Polycom, Inc. 15