Prepare The Hardware Installation Site; Site Safety Requirements - Polycom RealPresence RMX 4000 Hardware Manual

Prepare the Hardware Installation Site

This section introduces instructions you need to know before installing the RealPresence Collaboration
Server
2000.
●
Prepare the Hardware Installation Site
●
Unpack the RealPresence Collaboration Server (RMX) 4000
●
Verify the Accessories Kits
●
Install the Telescopic Rail Runner on the Rack
Prepare the Hardware Installation Site
This section describes the requirements your site must meet for the safe installation and operation of the
system.

Site Safety Requirements

For your protection, please read these safety instructions completely before operating the equipment.
● Look carefully for potential hazards in your work area: moist floors, ungrounded power cables, frayed
power cords, missing safety grounds and so forth.
● Locate the main circuit breaker within the room.
● Locate the emergency power OFF switch within the room.
● Never assume that power is disconnected from a circuit.
● Use only the power cords supplied with the system.
● Each power cord should only be connected to a power outlet that has a protective ground contact.
● Ensure that power cords are easily accessible from the back of the system at all times.
● Place the equipment in a well-ventilated area where the vents are free from obstruction.
● Do not place heavy objects directly on top of the RealPresence Collaboration Server (RMX) 4000
unit.
● Do not use liquids around your equipment.
● Keep the area around the RealPresence Collaboration Server (RMX) 4000 clean and free of clutter.
● Decide on a suitable location for the equipment rack that will hold the RealPresence Collaboration
Server (RMX) 4000 unit. It should be situated in a clean, dust-free area that is well ventilated. Avoid
areas where heat, electrical noise and electromagnetic fields are generated. You will also need to
place it near a grounded power outlet.
Polycom, Inc. 22