Executing The Diagnostic Test - Toshiba Tecra 700CS Maintenance Manual

3.2

Executing the Diagnostic Test

Toshiba MS-DOS is required to run the Diagnostics program. To start the program, follow
the steps listed below.
1. Insert the Diagnostics disk in the computer's floppy disk drive and turn on the
computer.
NOTE: To execute the CD-ROM test, make sure the CD-ROM drive and test
CD-ROM are installed in the computer and the FDD is attached to the FDD
port.
The following menu will appear:
TOSHIBA personal computer xxx DIAGNOSTICS
version X.XX (c) copyright TOSHIBA Corp. 19XX
DIAGNOSTICS MENU :
1 - DIAGNOSTIC TEST
2 - HARD DISK FORMAT
3 -
4 - HEAD CLEANING
5 - LOG UTILITIES
6 - RUNNING TEST
7 - FDD UTILITIES
8 - SYSTEM CONFIGURATION
9 - EXIT TO MS-DOS
0 - SETUP
NOTE: To exit the DIAGNOSTIC TEST menu, press the Esc key. If a test
program is in progress, press Ctrl + Break to exit the test program, or press
Ctrl + C to stop the program.
700 Series
↑ ↓ → ←
: Select items
Enter : Specify
Esc : Exit
3-3