Toshiba Tecra 700CS Maintenance Manual page 176

7. Lift out the FL.
Installing the DSTN FL
To install the DSTN FL, follow the steps below and refer to Figures 4-45 back to 4-43.
1. Lay the FL in the groove of the cover assembly.
2. Replace the FL cover and slide it into place to engage the nine latches.
3. Secure one M2x1.5 screw and one M2x2.5 screw.
4. Connect the flexible cable to CN-SU.
5. Retape the SEG board with new tape.
6. Install the LCD module, FL inverter board, display mask, optional PCMCIA card,
optional memory module, and the battery pack as described in Sections 4.20, 4.18,
4.17, 4.4, 4.3 and 4.2.
4-52
Figure 4-44 Removing the FL cover
Figure 4-45 Removing the DSTN FL
700 Series