Toshiba Tecra 700CS Maintenance Manual page 96

2. Good track FORMAT
This option formats a specified cylinder and track as a good track. If a good
track is formatted as a bad track, use this option to change the track to a good
track.
3. Bad track FORMAT
This option formats a specified cylinder and track as a bad track. If a bad
track is detected, use this option to label it as a bad track.
4. Bad track CHECK
This option searches the hard disk for bad tracks by reading data to all the
tracks on the hard disk. A list of bad tracks is displayed when the program is
complete. If an error other than a bad track is detected, the program is auto-
matically terminated.
3.19.2 Operations
NOTE: After the HDD has been formatted, execute the Toshiba MS-DOS FDISK
command to partition the HDD. Next, execute the Toshiba MS-DOS FORMAT com-
mand. Refer to the Toshiba MS-DOS manual for more information about using these
commands.
Selecting 2 and pressing Enter in the DIAGNOSTIC MENU displays the following
submenu:
DIAGNOSTICS - HARD DISK FORMAT : VX.XX
1 - All track FORMAT
2 - Good track FORMAT
3 - Bad track FORMAT
4 - Bad track CHECK
9 - Go to TEST MENU
↑ ↓ → ← : Select items, Enter: Finish, Esc: Exit
3-42
700 Series