Toshiba Tecra 700CS Maintenance Manual page 170

Installing the TFT FL inverter board
To install the TFT FL inverter board, follow the steps below and refer to Figure 4-40.
1. Connect the FL inverter cable to CN1 on the inverter board and the FL cable
to CN2.
2. Route the cables so they are not pinched by the FL inverter board, display hinge or
other component.
3. Replace the FL inverter board, lining up the holes in the board with the guide pins,
then secure it with an M2.5x6 screw.
4. Install the display mask, optional PCMCIA card, optional memory module, and
battery pack as described in Sections 4.17, 4.4, 4.3 and 4.2.
4-46
700 Series