Table of Contents
Advertisement
12.
Disconnect the flexible cable by pulling it out from the FDD (Figure 4-9).
13.
Remove four M2x3 screws and remove the FDD from the bracket.
Installing the FDD
To install the FDD, follow the steps below and refer to Figures 4-10 back through 4-6.
1.
Seat the FDD in the metal bracket and secure it with four M2x3 screws.
2.
Insert the flexible cable into the flexible cable connector on the FDD.
3.
Seat the FDD in the lower plastic cover and set the plate in place.
4.
Seat the FDD cable connector into the lower plastic cover.
5.
Set the upper plastic cover in place, snapping the latches to seat the cover, then
secure the cover with six M2x6 screws.
6.
Turn the computer over.
7.
Insert the FDD in the computer and press gently until it locks into place.
8.
Close the LED indicator cover.
9.
Slide the cover to the right to engage the latches.
4-14
Figure 4-9 Removing the FDD from its bracket
700 Series
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
