Toshiba Tecra 700CS Maintenance Manual page 129

Tools and Equipment
The use of ElectroStatic Discharge (ESD) equipment is very important for your safety and the
safety of those around you. Proper use of these devices will increase the success rate of your
repairs and lower the cost for damaged or destroyed parts. The following equipment is
necessary to disassemble and reassemble the computer:
One M2 Phillips screwdriver to remove and replace screws.
Tweezers to lift out screws that you cannot grasp with your fingers.
A jeweler's screwdriver to remove screw masks.
ESD mats for the floor and the table you are working on.
An ESD wrist strap or heel grounder.
Antistatic carpeting or flooring.
Air ionizers in highly static sensitive areas.
Screw Tightening Torque
When you fasten screws, be sure to follow the torque list below. Over tightening can damage
components and screws; under tightening can result in electrical shorts or other damage if
screws or components come loose.
M2 0.22 N•m (2.2 kgf•cm)
M2.5 0.36 N•m (3.5 kgf•cm)
FDD 0.22 N•m (2.2 kgf•cm)
HDD 0.3 N•m (3.1 kgf•cm) or less
700 Series
4-5