Toshiba Tecra 700CS Maintenance Manual page 148

5. Disconnect the AccuPoint control button flexible cable from PJ702 on the IPS
board (Figure -22).
CAUTION: 1. Handle the LCD flexible cable with care since stress in the
6. Disconnect the LCD cable from PJ703 on the IPS board.
7. Disconnect the FL inverter cable from PJ705.
8. Lift up the left speaker, then disconnect the sensor cable from PJ708 on the IPS
board.
9. Disconnect the microphone from PJ4 on the infrared board.
10. Remove the white glass tape, lift out the right speaker, then disconnect the
speaker cable from PJ5 on the sound board. Note the routing of the speaker
cables in the mylar insulators.
11. Peel back the black tape on the LCD cable, remove the speakers, then replace the
tape.
12. Lift out the volume control knob with its mylar washer.
4-24
bends of the cable may cause damage.
2. Do not completely remove the black or yellow tape on the
LCD flexible cable.
Figure 4-22 Removing cables
700 Series