Toshiba Tecra 700CS Maintenance Manual page 168

Installing the DSTN FL inverter board
To install the DSTN FL inverter board, follow the steps below and refer to Figure 4-39.
1. Connect the FL inverter cable to CN1 on the inverter board and the FL cable to
CN2.
2. Route the cables so they are not pinched by the FL inverter board, display hinge or
other component.
3. Replace the FL inverter board and secure it with one M2.5x6 screw.
4. Connect the contrast control board cable and seat the contrast control board.
5. Secure the contrast control board with one M2.5x6 screw.
6. Install the display mask, optional PCMCIA card, optional memory module, and
battery pack as described in Sections 4.17, 4.4, 4.3 and 4.2.
4-44
700 Series