Toshiba Tecra 700CS Maintenance Manual page 128

Disassembly Procedures
The computer has three basic types of cable connectors:
Pressure Plate Connectors
Normal Pin Connectors
Flexible Cable Connectors
To disconnect a pressure plate connector, lift up the tabs on either side of the connector's
plastic pressure plate and slide the cable out of the connector. To connect the cable, make
sure the pressure plate is fully lifted and slide the cable into the connector. Secure the cable in
place by pushing the sides of the pressure plate down so the plate is flush with the sides of the
connector. Gently pull on the cable to make sure it is secure. If you pull out the connector,
connect it again making sure the connector's pressure plate is fully lifted when you insert the
cable.
Standard pin connectors and flexible cable connectors can be connected and disconnected by
simply pulling them apart or pushing them together.
Assembly Procedures
After you have disassembled the computer and fixed or repaired the problem that was causing
it to operate abnormally, you will need to reassemble the computer. During reassembly,
remember the following general points:
Take your time and make sure you follow the instructions closely. Most problems
arise when you get in a hurry.
Make sure all cables and connectors are securely fastened.
Before securing the FRU or other parts, make sure that no cables will be pinched by
screws or the FRU.
Check that all latches are closed securely.
Make sure the correct screws are used to secure all FRUs. Using the wrong screw can
damage the threads or the head of the screw, and may prevent proper seating of an
FRU.
After installing an FRU, confirm that it and the computer are functioning properly.
4-4
700 Series