Toshiba Tecra 700CS Maintenance Manual page 144

7. Remove the two flat screws securing the HDD to the case and lift out the HDD.
8. Carefully pull off the HDD connector.
Installing the Hard Disk Drive
To install the hard disk drive, follow the steps below and refer to Figures 4-17 back through
4-15.
1. Connect the HDD connector.
2. Seat the HDD in the case and place the HDD connector holder into the long tab.
3. Secure the two flat screws.
4. Put the HDD cover in place; then place your hand on the cover and press lightly to
ensure the cover seats completely. Verify the HDD connector holder is seated
properly.
5. Secure the four flat M3x4 screws, then apply a VOID seal.
6. Turn the computer upside down, slide the LED indicator cover to the left, and
rotate the cover up.
7. Insert the HDD, VOID label side up, and press to ensure a firm connection.
8. Install the optional CD-ROM drive or FDD, optional memory module, optional
PCMCIA card, and battery pack as described in Sections 4.6 back through 4.2.
4-20
Figure 4-17 Removing the HDD
700 Series