Toshiba Tecra 700CS Maintenance Manual page 161

9. Remove the system board and frame from the bottom cover.
Figure 4-33 Separating the system board and frame from the bottom cover
Installing the Bottom Cover
To install the bottom cover, follow the steps below and refer to Figures 4-33 back through 4-
30.
1. Seat the system board and frame in the bottom cover.
2. Secure five M2.5x6 screws.
3. Seat the flexible cable assembly. Be sure the black insulator is on top of the flexible
cable on the right.
4. Connect PJ5 to PJ17 on the system board and PJ1 to PJ7 on the system board
flexible cable.
5. Seat the plastic base on the HDD connector.
6. Place the metal cover in the bottom assembly.
7. Secure four flat M2.5x4 screws on the metal cover.
8. Install the power supply board, IPS board, sound board, infrared board, keyboard
base and display assembly, upper cover and keyboard, HDD, FDD or optional CD-
ROM drive, optional PCMCIA card, optional memory module, and battery pack as
described in Sections 4.13 back through 4.2.
700 Series
4-37