Toshiba Tecra 700CS Maintenance Manual page 133

4. Grasp the memory module and lift it to disconnect it from the computer.
Installing an Optional Memory Module
To install an optional memory module, make sure the computer is in boot mode, then follow
the steps below and refer to Figures 4-2 and 4-3.
1. Position the module's connector over the corresponding connector on the system
board.
CAUTION: Do not touch the connectors on the memory module or on the
computer. Debris on the connectors may cause memory access problems.
2. Place your fingers above the connector and press firmly but gently to ensure a
solid connection. The module should be seated level.
3. Seat the memory slot cover and secure it with two M2.5x4 silver screws.
4. Install the battery pack as described in Section 4.2.
700 Series
Figure 4-3 Disconnecting the memory module
4-9