3 Tests and Diagnostics
3.2
Executing the Diagnostic Test
To start the DIAGNOSTIC PROGRAM, follow these steps:
1. Insert the Diagnostics disk in the floppy disk drive.
2. Release the lock of the power switch and turn on the computer with pressing the F12.
Select the FDD in the display for selecting booting unit. Then, press Enter and the
following menu appears.
Microsoft Windows XX Startup Menu
---------------------------------------------------------
1. Repair Main (T&D)
2. Repair initial config set
3. Repair Heatrun (T&D)
Enter a choice: 1
Select the program you want to execute and press Enter. The RAID configuration check
screen will be displayed. Refer to 3.3 RAID configuration Check.
When any key is pressed, the RAID configuration check screen is completed and the
program selected is executed.
To start the Diagnostics menu (T&D), press 1 and Enter.
To start the H/W initial information setting tool, press 2 and Enter.
To start the Heatrun test, press 3 and Enter.
NOTE: After replacing the system board or CPU, it is necessary to execute the subtest
01 Initial configuration in 3.4 Setting of the hardware configuration.
3-4
Downloaded from LpManual.com Manuals
3.2 Executing the Diagnostic Test
PORTEGE S100 Maintenance Manual (960-508)