Toshiba Tecra 700CS Maintenance Manual page 49

Procedure 4 Connector Check
The display unit has an LCD module, FL, display switch, and FL inverter board. The FL and
FL inverter board are connected by two cables, and the LCD module and system board are
connected by two signal cables (TFT display) as shown below. Any of these cables may be
disconnected.
Disassemble the display unit and check the following cable connections. Refer to Chapter 4,
Replacement Procedures, for more information on how to disassemble the computer.
Figure 2-3 DSTN display connection
2-29
700 Series