Toshiba Tecra 700CS Maintenance Manual page 33

Check 2 If the following error message displays, press any key as the message instructs.
WARNING:
PRESS ANY KEY TO CONTINUE.
This message appears when data stored in RAM under the resume function is lost
because the battery has become discharged or the system board is damaged. Go
to Procedure 3.
If any other message appears, perform Check 3.
Check 3 The IRT checks the system board. When the IRT detects an error, the system
stops or an error message appears.
If any of the following error messages display, replace the system board:
(1) through (17), (24) or (25).
If error message (18) displays, go to the Keyboard Troubleshooting
Procedures in Section 2.7.
If error message (19), (20) or (21) displays, go to the HDD
Troubleshooting Procedures in Section 2.6.
If error message (22) or (23) displays, go to the FDD Troubleshooting
Procedures in Section 2.5.
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(10)
(11)
(12)
(13)
(14)
(15)
(16)
(17)
(18)
(19)
(20)
(21)
(22)
(23)
(24)
(25)
700 Series
RESUME FAILURE.
PIT ERROR
MEMORY REFRESH ERROR
TIMER CH.2 OUT ERROR
CMOS CHECKSUM ERROR
CMOS BAD BATTERY ERROR
FIRST 64KB MEMORY ERROR
FIRST 64KB MEMORY PARITY ERROR
VRAM ERROR
SYSTEM MEMORY ERROR
SYSTEM MEMORY PARITY ERROR
EXTENDED MEMORY ERROR
EXTENDED MEMORY PARITY ERROR
DMA PAGE REGISTER ERROR
DMAC #1 ERROR
DMAC #2 ERROR
PIC #1 ERROR
PIC #2 ERROR
KBC ERROR
HDC ERROR
HDD #0 ERROR
HDD #1 ERROR
NO FDD ERROR
FDC ERROR
TIMER INTERRUPT ERROR
RTC UPDATE ERROR
2-13