Expansion Test - Toshiba Tecra 700CS Maintenance Manual

3.14 Expansion Test

NOTE: To execute this subtest, the PCMCIA wraparound connector is required.
Subtest 01 PCMCIA wraparound (Main) (Point to point (Receive))
This test checks the following signal lines of the PCMCIA slot:
Address line
REG#, CE#1, CE#2 line
Data line
Speaker line
Wait line
BSY#, BVD1 line
The subtest is executed in the following order:
Sub#
01
02
03
04
05
NOTE: Subtests 02 through 09 are for the Desk Station V. For procedures on these
subtests, refer to the Desk Station V Maintenance Manual.
Subtest 02 PCMCIA wraparound (DS-V)
Subtest 03 DS bus wraparound (DS-V)
Subtest 04 PCI bus wraparound (DS-V)
Subtest 05 ISA bus wraparound (DS-V)
Subtest 06 SCSI bus wraparound (DS-V)
Subtest 07 RGB monitor ID
Subtest 08 Joystick
Subtest 09 Joystick wraparound
3-32
Address Good
00001 nn
00001 nn
00002 ww
00003 --
00004 40, 80
00005 nn
Bad Contents
xx Address line
xx REG#, CE#1, CE#2
nn=A0, 90, 80, 00
rr Data line
ww=write data, rr=read data
-- Speaker line
xx Wait line (40<xx<80)
xx Other lines (BSY#, BVD1)
nn=21, 00
700 Series