Toshiba Tecra 700CS Maintenance Manual page 151

9. Seat the speakers under the mylar insulators. Be sure to peel back the tape on the
LCD cable to route the speaker cable under the tape, then replace the tape. Route
the speaker cables through the insulators to the right of the LCD cable.
10. Connect the speaker cable to PJ5 on the sound board, then place the cables in the
well next to the right speaker. Be sure not to pinch the cables.
11. Connect the microphone cable to PJ4 on the infrared board.
12. Connect the FL inverter cable to PJ705.
13. Connect the LCD cable to PJ703 on the IPS board.
14. Connect the AccuPoint control button flexible cable to PJ702 on the IPS board.
15. Place the volume control knob with its mylar washer in the keyboard base.
16. Close the display.
17. Turn the computer over and secure one M2.5x6 silver screw in the battery pack
slot and three M2.5x20 silver screws.
18. Install the keyboard, upper cover, HDD, optional CD-ROM drive or FDD,
optional memory module, optional PCMCIA card, and battery pack as described in
Sections 4.8 back through 4.2.
700 Series
4-27