Installing the IPS Board and RTC battery
To install the IPS board and RTC battery, follow the steps below and refer to Figure 4-27.
1.
Connect the drive connector flexible cable to PJ701.
2.
Seat the IPS board.
3.
Secure one M2.5x6 screw.
4.
Seat the RTC battery and secure the battery and cable with tape.
5.
Route the RTC battery cable in its channel and connect it to PJ707.
6.
Install the sound board, infrared board, speakers, keyboard base and display
assembly, upper cover and keyboard, HDD, FDD or optional CD-ROM drive,
optional PCMCIA card, optional memory module, and battery pack as described in
Sections 4.11 back through 4.2.
4-32
700 Series