Toshiba Tecra 700CS Maintenance Manual page 150

18. Remove two M2.5x4 screws and two M2.5x6 screws.
19. Lift off the metal cover.
Installing the Speakers, Keyboard Base, and Display Assembly
To install the speakers, keyboard base, and display assembly, follow the steps below and refer
to Figures 4-24 back through 4-21.
1. Seat the metal cover inserting the hooks on the left of the cover between the base
assembly and frame assembly.
2. Secure two M2.5x4 screws and two M2.5x6 screws.
3. Connect the sensor cable to PJ708 on the infrared board.
4. Seat the keyboard base and display assembly, securing the latches around the
edges.
5. Secure two M2x4 silver screws under the front of the keyboard base.
6. Secure six M2.5x6 screws. Refer to Figure 4-23 for locations of ground wires.
NOTE: On units with a keyboard lock, replace five M2.5x6 screws to secure
the keyboard base.
7. Secure one M2.5x20 silver screw.
8. Seat the PCMCIA card cover and secure it with two M2.5x4 screws.
4-26
Figure 4-24 Removing the metal cover
700 Series