Toshiba Tecra 700CS Maintenance Manual page 143

4.7 Hard Disk Drive (HDD)
Removing the Hard Disk Drive
To remove the hard disk drive, follow the steps below and refer to Figures 4-15 to 4-17.
1. Turn off the power to the computer, then disconnect the AC adapter and all
external cables connected to the computer.
2. Remove the battery pack, optional memory module, optional PCMCIA card, and
FDD or optional CD-ROM drive as described in Sections 4.2 through 4.6.
3. Slide the LED indicator cover to the left to free it from the latches.
4. Rotate the cover up.
5. Grasp the plastic handle and pull out the HDD.
6. Peel off the VOID seal, then remove the four flat M3x4 screws securing the
cover to the pack. Slide the cover forward slightly (about 2 cm) and lift it off.
700 Series
Figure 4-15 Removing the HDD
Figure 4-16 Removing the HDD cover
4-19