Toshiba Tecra 700CS Maintenance Manual page 115

(b) Infrared Port
Sets the COM level for the infrared port. The infrared port interrupt
request level (IRQ) and I/O port base address for each COM level is
shown below.
NOTE: If the setting for the serial port is the same as that for the
infrared port, the infrared port is automatically set to disabled.
(c) Parallel Port
Sets the address for the parallel port. The options are:
When you select one of the above options, except for Not used, a
subwindow similar to the one below appears to let you set the parallel
port mode. The options for this setting are ECP (Default) and Std.Bi-
Directional.
For most printers, the port should be set to ECP. With some other
parallel devices, the setting should be Std.Bi-Directional.
700 Series
COM level Interrupt level
COM1 4
COM2 3
COM3 4
COM4 3
Not used
LPT1 (378H) Sets the address to 378H. (Default)
LPT2 (278H) Sets the address to 278H.
LPT3 (3BCH) Sets the address to 3BCH.
Not used Disables the port.
Option
Mode
I/O address
3F8h (Serial port default)
2F8h
3F8h
2F8h
(Disables port) (Infrared port default)
= ECP
3-61