Installing an Optional CD-ROM Drive
To install a CD-ROM drive, follow the steps below and refer to Figures 4-14 back through 4-
11.
1.
Seat the cover and connect the cable connector.
2.
Push the CD-ROM drive fully into the frame.
3.
Secure the frame to the drive with four M2x3 screws and two M2.5x6 screws.
4.
Turn the computer upside down.
5.
Insert the CD-ROM drive in the computer and press gently until it locks into place.
6.
Close the LED indicator cover.
7.
Slide the cover to the right to engage the latches.
8.
Install the optional PCMCIA card, optional memory module and battery pack as
described in Sections 4.4, 4.3 and 4.2.
4-18
Figure 4-14 Installing the CD-ROM drive
700 Series