Toshiba Tecra 700CS Maintenance Manual page 174

Installing the FL Inverter Cable and Display Cable
To install the FL inverter cable and display cable, follow the steps below and refer to Figure
4-42.
1. Connect the FL inverter cable, contrast control board cable (DSTN only), and
display cable on the LCD module. Route the FL inverter cable through the mylar
insulators.
2. Secure a ground cable to the system board with an M2.5x6 screw.
3. Secure a ground cable to the left hinge with an M2.5x6 screw.
4. Secure a ground cable to the computer with an M2.5x6 screw.
5. Secure a ground cable to the right hinge with an M2.5x6 screw.
6. Install the LCD module (for display cable only), FL inverter board, display mask,
speakers, keyboard base and display assembly, upper cover and keyboard, HDD,
CD-ROM drive or FDD, optional PCMCIA card, optional memory module, and
battery pack as described in Sections 4.20, 4.19 (TFT display) or 4.18 (DSTN
display), 4.17, and 4.9 back through 4.2.
4-50
700 Series