Opening The Front Panel - Invacare Storm4 Series Service Manual

®
Invacare - STORM
8.1.3

Opening the front panel

Requirements:
· 4 mm Allen key
Dismantling the front cover panel:
·
Use the lifter to move the seat to the uppermost position. If a lifter is not available, you have to
remove the seat as described in chapter 8.15.1.1 or 8.15.1.3 respectively.
·
Remove the rear and centre cover as described in chapters 8.1.1 and 8.1.2.
·
Loosen the two Allen screws (1) – concealed by the motor in the picture – using a 4 mm Allen
key.
·
Pull the motor cable and the guide bushes (2) out of the lateral recesses.
·
Pull the connecting cable to the seat out of the recess (3).
·
First lift the front cover up so that the retaining clips (4) are exposed.
·
Then pull the cover off towards the front.
Refitting the front panel:
·
Refit the parts in reverse order.
·
Make sure that the retaining clips (4) snap securely into the openings of the cover.
·
Now tighten all the screws finger-tight again.
4 ®
Series SERVICE MANUAL
43