Rear Wheel Suspension; Replacing The Rear Wheel Suspension - Invacare Storm4 Series Service Manual

®
Invacare - STORM
8.13

Rear wheel suspension

8.13.1 Replacing the rear wheel suspension

WARNING: Danger of crushing!
The mobility device is very heavy. Injury hazard to hands and feet!
· Use proper lifting techniques:
Injury hazard caused by uncontrolled movement of the mobility device!
· Switch the power supply off (ON/OFF key).
· Engage the drive.
· Before raising the vehicle, secure the wheels by blocking them with wedges.
Requirements:
· 5 mm Allen key
· 6 mm Allen key
· T40 torx wrench
· 13 mm socket spanner
· 19 mm socket spanner
· blade screwdriver
· long wooden blocks, min. 14 x 14 x 30 cm
Dismantling the wheel suspension:
·
Remove the rear and the centre battery compartment cover as described in chapters 8.1.1 and
8.1.2.
·
Remove the rear light cover as described in chapter 8.1.4.
·
Pull the motor plug out of the power module.
·
Open the cable clamps and expose the motor cable.
·
Remove the drive wheel as described in chapter 8.10.1.
·
Remove the wheel hub as described in chapter 8.10.3.
·
Remove the splash guard as described in chapter 8.1.6.
·
Remove the motor/transmission unit as described in chapter 8.11.1 or 8.11.3.
4 ®
Series SERVICE MANUAL
141