Invacare Storm4 Series Service Manual page 72

SERVICE MANUAL
·
Lead the cables on the modules fitted at the rear (power module and actuator module) through
the recess in the battery flap under the actuator module to the cable bridge (1).
·
Lead the cables inside the covers over the cable bridge (1).
·
Fasten the cables with the cable clamps (2). The cable clamps on the front side of the battery
compartment for the cables of the optional lifter are not seen in the picture.
·
The motor cables are fitted with protection covers (2) and are guided out of the front cover
through recesses on the side.
·
Cables that lead to the seat (upper actuator module, remote, headlight), are guided out of the
front cover through an upper left recess (3).
·
Make sure the cable has enough play so that all movable parts can move freely without
stretching, clamping or abrading the cable.
·
Lay the cables in the same way under the seat and to the remote. Fasten the cables with the
prescribed cable clamps or cable ties respectively.
72
®
Invacare - STORM
4 ®
Series