SERVICE MANUAL
9.4
Fitting the headrest
9.4.1
Fitting the headrest to the standard back
Requirements:
· 5 mm Allen key
· 10 mm socket spanner
·
Gripping it at the base, hold the lower section of the headrest mounting (4) with the clamp
block against the handlebar (3).
·
Attach the clamp cover (2.
·
Insert the four Allen screws (1) from above through the boreholes.
·
Fit the four cap nuts (5) to the screws from underneath.
·
Use a 5 mm Allen key and a 10 mm socket spanner to tighten the screws and the cap nuts.
·
Fit the headrest in the guide bar.
194
®
Invacare
- STORM
4 ®
Series