Replacing The G-Trac Sensor - Invacare Storm4 Series Service Manual

SERVICE MANUAL
8.2.7

Replacing the G-Trac sensor

Requirements:
· 5 mm Allen key
· 10 mm socket wrench
Dismantling the G-Trac sensor:
·
If possible, completely raise the seat with the lifter.
·
Switch the electronics of the wheelchair OFF.
·
Remove the rear cover, as described in chapter 8.1.1.
·
Take note of the positions of all cables and the sockets that they are connected to. Mark the
connectors and sockets or take a photograph with a digital camera.
·
In the illustrations you see the power module (4), the optional lighting circuit board (2), the
optional actuator module (1) & (3) as well as the G-Trac sensor (5)
56
®
Invacare - STORM
4 ®
Series