Adjusting The Seat Depth (Standard Seat) - Invacare Storm4 Series Service Manual

SERVICE MANUAL
·
Release the two upper front Allen screws (9) on the seat mounting plate and remove them.
·
Loosen the four Allen screws at the front (7) and at the rear (8) that can be found on the side of
the seat mounting plate in order to release tension and facilitate moving the plates. Do not
remove these screws entirely.
·
Pull or push the seat mounting plate (2) to the desired width. A scale (3) is included on the
lower part of the seat support. You can read off the seat width in centimetres on the scale.
·
Repeat these work steps on the other side of the seat.
·
Now tighten all the screws again.

10.3.2 Adjusting the seat depth (standard seat)

Note
The seat depth can be adjusted in stages between 38 and 53 cm.
Please also observe preceding chapter 10.3.2 on "adjusting the seat width".
Note
Depending on the width and depth of the seat, the splash guards must also be replaced. Please
also observe chapter 8.1.6 on "replacing the splash guard".
Requirements:
· 4 mm Allen key
· 8 mm jaw spanner
· Oblique pliers
· Cable ties
Note
Certain holes in the seat support must be used for the screws depending on the desired seat
depth. It may possibly be necessary to replace the seat support plates.
·
Use the following illustration and the table to determine which holes must be used for the
desired seat depth and whether the seat support plates possibly have to be replaced.
Seat frame front:
Seat frame rear:
214
®
Invacare - STORM
4 ®
Series