Invacare Storm4 Series Service Manual page 79

®
Invacare - STORM
·
Loosen the two cap nuts (2) using an 8 mm spanner and remove the headlight with the
mounting from the rubber bumpers.
·
There are two Phillips screws, (cannot be seen in the picture), that fasten the headlight to the
mounting. Loosen the two Phillips screws in order to remove the headlight from the mounting.
·
Replace the headlight unit.
Refitting the front headlight:
·
Refit the parts in reverse order.
·
Lay the cables carefully and fasten them using the cable clamps and cable ties. In doing so,
please pay attention to chapter 8.6.1.
·
Now tighten all the screws finger-tight again.
·
Check all vehicle functions.
·
Adjust the headlight roughly using the grid. The user can carry out the final adjustment
following the operating manual.
4 ®
Series SERVICE MANUAL
79