Invacare Storm4 Series Service Manual page 112

SERVICE MANUAL
·
Remove the valve cover (2).
·
Press the release pin in the valve inwards and evacuate all the air from the tyre.
·
Undo the five 6 mm Allen screws (4) on the inside of the wheel.
·
Remove the inner (3) and outer (6) ring of the rim from the tyre (1).
·
Replace any defective or worn parts.
Refitting the tyres:
·
Refit the inner tube in the tyre.
Note
If the old inner tube is to be repaired and re-used, and has become wet during repair, you can
make replacement easier by sprinkling the inner tube with a little talcum powder.
·
Refit rim rings (3) and (6) to the tyre. Please ensure that the boreholes and thread for the
screws are exactly above each other.
·
Fill some air into the inner tube.
·
Refit the five Allen screws on the inner side of the wheel and tighten them.
·
Check the exact fit of the tyre on the rim.
·
Inflate the tyre to the prescribed air pressure.
·
Re-check the exact fit of the tyre on the rim.
·
Screw the valve cap back on.
·
Refit the wheel.
112
®
Invacare - STORM
4 ®
Series