Invacare Storm4 Series Service Manual page 217

®
Invacare - STORM
·
Refit the Allen screws (5) incl. the washers and tighten them.
·
If necessary, replace the seat support plates (2) according to the table (see above).
·
Refit the seat support plate (2).
·
Fit the two Allen screws (7) on the front side of the seat support, connecting this to the cross
braces (4).
·
Fit the two Allen screws (8) on the rear side of the seat support, connecting this to the cross
braces (4). Unlike the dismantling of the old plates, other holes of the three pairs of holes may
possibly have to be used for the screws.
·
Fit the two Allen screws (9) at the front of the seat support plate.
·
Refit all parts that were removed.
·
If necessary, replace the splash guards as described in chapter 8.1.6.
4 ®
Series SERVICE MANUAL
217