SERVICE MANUAL
7.1.3
Opening the front panel
Requirements:
4 mm Allen key
Dismantling the front cover panel:
Remove the seat, as described in chapters 7.6.1 and 7.6.5.
Remove the rear and the middle covers, as described in chapter 7.1.1 and 7.1.2.
Loosen the two Allen screws (1) – concealed by the motor in the picture – using a 4 mm Allen
key.
Pull the motor cable and the guide bushes (2) out of the lateral recesses.
Pull the connecting cable to the seat out of the recess (3).
First lift the front cover up so that the retaining clips (4) are exposed.
Then pull the cover off towards the front.
Refitting the front panel:
Refit the parts in reverse order.
Make sure that the retaining clips (4) snap securely into the openings of the cover.
Now tighten all the screws finger-tight again.
36
®
4
Invacare
- STORM
MAX