Invacare Storm4 Series Service Manual page 118

SERVICE MANUAL
·
Loosen the four Allen screws (1) with a 6 mm Allen key and a 13 mm socket spanner..
·
Remove the screws together with the washers.
·
Pull the motor/transmission unit (3) out of the mounting (2) in a forward direction. In doing so,
please observe the high weight of the unit.
Refitting the motor/transmission unit:
·
Replace the defective parts.
· Check the serial number of the gearbox housing.
Up to the serial number 20110400xx, the gearbox housing is
44.5 mm wide: '
The compensation sheet (see right) must be installed.
Up to the serial number 20110400xx, the gearbox housing is
49.5 mm wide:
The compensation sheet is not necessary.
· Refit the motor/transmission unit in reverse order.
· Use the scale to align the motor to the centre axis (1).
- Left motor:
- Right motor:
· Make sure that the motor cable cannot be pinched or bent, and
that it is not exposed to chafing in any place.
· To conclude, you should always carry out a trial run to test the
vehicle functions
118
185°
5°.
®
Invacare - STORM
4 ®
Series