SERVICE MANUAL
8.7.9
Replacing the front bulb holder (LED lighting unit until 03/2012)
Requirements:
· 4 mm Allen key
· 8 mm spanner
Dismantling the bulbholder:
·
Loosen the Allen screw (1) using a 4 mm Allen key and remove the headlight from the
mounting.
·
Loosen the two cap nuts (2) using an 8 mm spanner and remove the headlight with the
mounting from the rubber bumpers.
·
Replace the mounting.
Refitting the bulbholder:
·
Refit the parts in reverse order.
·
Now tighten all the screws finger-tight again.
·
Check all vehicle functions.
·
Adjust the headlight roughly using the grid. The user can carry out the final adjustment
following the operating manual.
88
®
Invacare
- STORM
4 ®
Series